When the clock runs out of light, it can be annoying. We will therefore have to replace the display bulb of this Kia Cee D 2 Sw. Even if the dashboard remains functional, it lacks several information to circulate in good conditions. This action is not difficult to perform, but requires a minimum of thoroughness. It is also advisable to take photos at different stages to remind you of the opposite approach, especially regarding connectors. To execute this operation, count approximately a small half-hour . Regarding tools, a pair of screwdrivers will suffice. Now let's see how to change this bulb, step by step.
How to change the bulb on the Kia Cee D 2 Sw display
Depending on the release dates, the procedure may vary a little. It is possible that some covers or screws differ. Here is the procedure to follow in general.
- Start with remove the covers of the front panel which obstruct access to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove more than one screw. In this case, keep them carefully aside.
- Once the facade has been completely removed, you must disconnect connectors which connect to the clock bulb of the Kia Cee D 2 Sw. This will allow you to remove all of the connectors from the block, as long as you remember the location. Help yourself with your camera if it helps you.
- You can normally have access to the defective bulb. Carefully disassemble the bulb of the clock.
- Compare the new bulb with the previous one. This should be similar in terms of base and volume. The voltage also naturally.
- Place the new bulb by checking that it is at the bottom of its socket.
- Put the connectors in place.
- Put all the covers on the front.
Do not hesitate to leave us a comment if you have encountered particular problems.