Today we find these turbos in most cars on the market, as much on systems essences ou Diesel. Just before you start this task, you will of course have to be sure that the fault is with the turbo in this Kia Carens 3. However, since you are reading this article, it means that you probably know the source.change-turbo-Kia-Carens-3

How to change the turbo on your Kia Carens 3

Depending on the turbo to set up, some of the handling may fluctuate a bit. If you buy a turbocharger, it will always be supplied with an operating manual. The best is therefore that you follow it to the letter. That said, in case you have not yet made the purchase, here are the steps to follow in order to replace a turbo compressor for the Kia Carens 3. In fact you will know if you have the skills. Before you start, make sure you have all the tools adequate. You will have the use of a receptacle for the engine oil, a set of ratchets, a flat pliers, your allen keys as well as flat ones. Usually these turbochargers are found to come with an assembly kit that contains joints, studs but also a portion oil. It is still advisable to go to a professional quite simply because working with a pit is much easier to do the procedures. In addition, the turbocharger is a particularly delicate component on this Kia Carens 3. Even though the operation is not super laborious, we still advise you to go to a technician.

  • Change the engine block oil then replace this oil filter. Replace a little oil, but not too much. This is a necessary manipulation!
  • Remove all of the plugs found around the turbocharger of this Kia Carens 3.
  • Check that no foreign bodies are found within the housings, since this is undoubtedly a cause of the problem.
  • Remove the pipes but also all the screws but also the nuts that will hold this turbocharger.
  • Remove the turbocharger in place in the Kia Carens 3.
  • Reassemble the new turbocharger, checking that the locations correspond completely
  • Refit the oil return pipe
  • Reassemble each of the required screws and nuts
  • Fill the turbocharger using the oil supplied with the turbo
  • Start the turbine by hand to activate the turbocharger.
  • Connect all the components to the turbocharger of this Kia Carens 3.
  • Now that when each of the components happens to be installed, you will be able to start the engine block and run it for a few minutes.

Once the turbo is in place and the car has been running for a while, it is possible to drive the Kia Carens 3 to check that everything is working properly. It is also advisable to check the quantity of oil and water regularly in the following weeks. Write a comment if this text was useful to you. Good walk !