Nowadays you can find these turbos in most cars in circulation, whether in engines essences ou Diesel. Before starting DIY, you must of course be convinced that the problem comes from the turbo of your Smart Crossblade. However, since you are on this page, it shows that you probably know the reason.change-turbo-Smart-Crossblade

How to change the turbo of your Smart Crossblade

Depending on the turbo to be installed, some of the procedures may fluctuate very slightly. When you get a turbo it will always come with a note of achievement. It is therefore best that you follow it to the letter. That said, in the event that you have not yet made the purchase, you will find below the steps to follow in order to replace a turbo in the Smart Crossblade. In fact you will know what capabilities are needed. Before you start, make sure you have all of the tools indispensable. You will be using your oil container, a bunch of ratchet wrenches, your pliers, allen wrenches as well as wrenches. In general, these turbos will be sold with their mounting kit which contains joints, studs and a dose oil. However, we recommend that you go to a specialist because tinkering with a pit is even more practical for handling. In addition, the turbo happens to be a rather fragile constituent on the Smart Crossblade. Even if the operation is not particularly difficult, we still advise you to go to a specialist.

  • Change the engine oil and replace your oil filter. Add a little oil, in small quantities. This is an imperative phase!
  • Remove all the plugs that there are around the turbo of your Smart Crossblade.
  • Check that there are no foreign bodies in the casings, because this is undoubtedly a source of malfunction.
  • Remove the conduits but also all the screws but also the nuts that will support your turbo.
  • Remove the turbo in place in this Smart Crossblade.
  • Fit the all-new turbo, checking that the locations are totally suitable
  • Replace the oil return pipe
  • Replace all the necessary screws and nuts
  • Fill the turbo with oil from your syringe
  • Operate the turbine manually so that the turbo turns.
  • Connect all of the components to the turbo of this Smart Crossblade.
  • As soon as all the parts are assembled, you must start the engine and let it run for a few minutes.

Now that everything is in place but also that the engine has been running for at least 5 minutes, you will be able to take a ride in this Smart Crossblade so as to see that the assembly turns well. It is advisable at the same time to check the amount of oil and water quite often in the weeks that follow. Write a comment if our file has ever been useful. Good walk !