The advantage of an electric window regulator is undeniable compared to manual window regulators. However, it has the disadvantage of being much more restrictive in terms of repairs. Also, it is not necessarily obvious to pinpoint the nature of the fault. Here we will find out how to repair the electric window regulator of a Seat Tango . But before seeing the procedure to follow, you must be sure to know where the dysfunction comes from. Indeed, it is regularly unnecessary to change the entire window regulator, a simple repair will often work. Whether it's an electrical short circuit, or simply a lack of lubrication. Now that you're sure of the cause, let's get to the heart of the matter.
How to replace a Seat Tango window regulator
Changing a window regulator is relatively time-consuming. Depending on your expertise in the field, count approximately three hours to make sure you don't get caught up in time. Whether for a Seat Tango or another car, this manipulation is for experienced DIY enthusiasts. So let's look at how to do it, step by step. It is advisable to take photos at different times to help you reassemble the new window regulator.
Removing a window regulator on a Seat Tango
- Remove the entire door trim. From the handle to the mirror cover. This should be done relatively carefully with a flat screwdriver. You must ensure that you access the window regulator at all points without being obstructed. This manipulation is quite long to execute.
- Remove the window regulator seals from your Seat Tango. Again, it's important to be careful.
- Now that you have access to the window regulator, disconnect the connectors. You must then remove the motor from the window regulator if it is blocked.
- Release all the fasteners that hold the glass, then remove it. It is regularly better to place the window halfway up to carry out this operation. Of course you have to be very careful when moving the glass. It's best to put it on a rather thick sheet.
- Remove the window regulator completely. It is important to remember your position. You can take a picture of it if it helps you to install the new window regulator. The window regulator is regularly held in place by screws or rivets, so you must remove them.
The installation of an electric window regulator of a Seat Tango
- Fit the new window regulator. Make sure that its location is similar to the damaged window regulator. You will certainly have to use the fasteners that you have set aside.
- Replace the glass just as you removed it. It will regularly be necessary to rotate it a little so that it fits properly in its guide.
- Reconnect the connectors.
- Replace the seals you removed.
- Refit the entire door trim.
It's good, you now have a new and working window regulator . You will therefore have to switch on and test it.