The advantage of an electric window regulator is undeniable compared to manual window regulators. However, it has the disadvantage of being much more complex in terms of repairs. In addition, it is not necessarily easy to pinpoint the nature of the fault. Here we will see how to repair the electric window regulator of an Opel Monterey . But before seeing the procedure to follow, you must be certain to understand where the failure came from. Let's be clear, it is sometimes unnecessary to replace the entire window regulator, a simple repair can sometimes be enough. Whether it's an electrical short circuit, or just a lack of lubrication. Now that you've identified the source of the problem, let's get back to our topic.
Replacing an Opel Monterey window regulator: how to do it
The replacement of a window regulator is quite long. Depending on your expertise on the subject, count approximately two o'clock to make sure you don't get caught up in time. Whether it's on an Opel Monterey or on another car, this repair is for experienced DIY enthusiasts. So let's look at what to do, step by step. It is advisable to take photos at different times to help you install the new window regulator.
Removing a window regulator on an Opel Monterey
- Remove all of the door trim. From the mirror cover to the handle. This should be done very gently with a flat screwdriver. It will be necessary to ensure access to the window regulator at any point without being obstructed. This step is the longest to execute.
- Remove the window regulator seals from your Opel Monterey. Again, it is essential to do this with care.
- Now that you have access to the window regulator, remove the connectors. You can then release the motor from the window regulator if it is stuck.
- Release all of the fasteners that hold the glass, then take it out. It is sometimes better to place the window halfway up to be able to carry out this operation. Of course, great care must be taken when moving the glass. It is advisable to put it on a sufficiently thick sheet.
- Remove the window regulator as a whole. It is essential to memorize your position. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held by screws or rivets, it will therefore be necessary to remove them.
Installing an electric window regulator from an Opel Monterey
- Present the new window regulator. Make sure that its position is similar to the damaged window lifter. You will probably need to use the fasteners you have set aside.
- Reposition the glass just as you removed it. It will sometimes be necessary to rotate it slightly so that it fits correctly in its guide.
- Connect the connectors.
- Replace the seals that you have carefully removed.
- Refit all of the door trim.
It's good, you now have a new and functional window regulator . You can therefore switch on the ignition and test it.