The advantage of an electric window regulator is enormous compared to manual window regulators. However, it has the disadvantage of being much more restrictive in terms of repairs. Also, it is not always easy to pinpoint the nature of the problem. Here we will see how to replace the electric window regulator of a Nissan Invitation . But before you start, you need to be sure you understand where the malfunction came from. Indeed, it is from time to time unnecessary to change the entire window regulator, a simple repair will often work. Whether it's an electrical short circuit, or just a lack of lubrication. Now that you've identified the cause of the concern, let's get back to our topic.
How to replace a Nissan Invitation window regulator
The replacement of a window regulator is quite long. Depending on your expertise on the subject, count about two o'clock to make sure you have the time you need. Whether for a Nissan Invitation or another car, this manipulation is for experienced DIY enthusiasts. So let's see what to do, step by step. We advise you to take photos at different times to help you mount the new window regulator.
Removing a window regulator on a Nissan Invitation
- Remove the entire door trim. From the handle to the mirror cover. This should be done with enough caution with a flat screwdriver. It will be necessary to ensure access to the window regulator at any point without being obstructed. This step is the longest to execute.
- Disassemble the window regulator seals from your Nissan Invitation. Again, it is essential to take it delicately.
- Now that you have accessed the window regulator, remove the connectors. You must then release the window lifter motor if it is stuck.
- Remove all the fasteners that hold the glass, then release it. It is from time to time more judicious to position the window halfway up to execute this operation. Naturally, you will have to be very careful when moving the glass. It is best to put it on a rather thick sheet.
- Disassemble the window regulator completely. It is essential to memorize your location. You can take a picture of it if it helps you fix the new window regulator. The window regulator is occasionally held in place by screws or rivets, so you must remove them.
Installing an electric window regulator on a Nissan Invitation
- Position the new window regulator. Make sure that its position is similar to the damaged window lifter. You probably need to use the fasteners you have set aside.
- Reposition the glass in the same way as you removed it. It will be necessary from time to time to make it move a little so that it fits properly in its guide.
- Connect the connectors.
- Fit the seals that you have carefully removed.
- Refit the entire door trim.
That's it, you now have a new and working window regulator . So you have to put the ignition on and test it.