The advantage of an electric window regulator is substantial in comparison with manual window regulators. However, it has the defect of being much more complicated in terms of repairs. In addition, it is not always easy to identify precisely the source of the failure. Here we will see how to replace the electric window regulator of a Nissan Juke . But before seeing the procedure to follow, you must be sure to understand where the dysfunction comes from. Let's be clear, it's regularly unnecessary to replace the entire window regulator, a simple small repair can often suffice. Whether it's an electrical short circuit, or just a lack of lubrication. Now that you are sure of the source of the malfunction, let's get to the heart of the matter.
How to replace a Nissan Juke window regulator
Changing a window regulator is relatively tedious. Depending on your expertise in the field, plan approximately two o'clock to make sure you don't get caught up in time. Whether for a Nissan Juke or another car, this repair is for experienced DIY enthusiasts. So let's see what to do, step by step. We advise you to take a picture at different times to help you reassemble the new window regulator.
Removing a window regulator on a Nissan Juke
- Remove the entire door trim. From the mirror cover to the handle. This should be done relatively gently using a flat screwdriver. You must ensure that you access the window regulator at all points without being disturbed. This step is quite long to perform.
- Disassemble the window regulator seals from your Nissan Juke. Again, it is crucial to do this carefully.
- Now that you have accessed the window regulator, disconnect the connectors. You must then release the window lifter motor when it is blocked.
- Remove all the fasteners that hold the glass, then take it out. It is regularly more advisable to place the window halfway up to be able to carry out this operation. Of course, extreme care must be taken when moving the glass. It is advisable to place it on a rather thick sheet.
- Disassemble the window regulator as a whole. It is essential to memorize your position. You can take a picture of it if it helps you fix the new window regulator. The window regulator is regularly held by screws or rivets, so they must be removed.
Installation of an electric window regulator for a Nissan Juke
- Position the new window regulator. Make sure that its location is identical to the previous window regulator. You will probably need to use the fasteners you have set aside.
- Reposition the glass in the same way as you took it out. It will be regularly necessary to move it a little so that it fits properly in its guide.
- Connect the connectors.
- Replace the seals that you have carefully removed.
- Refit the entire door trim.
It's done, you now have a new and working window regulator . So you have to put the ignition on and test it.