The interest of an electric window regulator is undeniable compared to manual systems. However, it has the disadvantage of being much more restrictive in terms of repairs. Also, it is not necessarily easy to determine precisely the cause of the failure. With this article we will find out how to replace the electric window regulator of a Seat Ateca . But before seeing the procedure to follow, you must be sure to understand where the failure came from. Let's be clear, sometimes it's unnecessary to replace the entire window regulator, a simple small repair can sometimes be enough. Whether it concerns a false contact, or quite simply a lack of lubrication. Now that you're sure where the problem is, let's get to the heart of the matter.
How to replace a Seat Ateca window regulator
Changing a window regulator is relatively tedious. Depending on your expertise on the subject, plan approximately two o'clock to make sure you have the necessary time. Whether for a Seat Ateca or on another car, this repair is for experienced DIY enthusiasts. So let's look at what to do, point by point. It is advisable to take a picture in several steps to help you reassemble the new window regulator.
Removing a window regulator on a Seat Ateca
- Remove the entire door trim. From the handle to the retro cover. This operation should be done relatively delicately using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being disturbed. This step is the longest to perform.
- Remove the window regulator seals from your Seat Ateca. Again, it's important to go about it gently.
- Now that you have accessed the window regulator, disconnect the connectors. You must then release the window lifter motor if it is ever stuck.
- Take out all the clips that hold the glass, then take out the glass. It is sometimes advisable to place the glass halfway up to perform this operation. Of course, you have to be very careful when moving the window. It is best to place it on a rather thick sheet.
- Remove the window regulator as a whole. It is important to remember your position. You can take a picture of it if it helps you fit the new window regulator. The window regulator is sometimes held by screws or rivets, so you have to remove them.
The installation of an electric window regulator of a Seat Ateca
- Fit the new window regulator. Make sure that its position is similar to the previous window regulator. You should definitely use the fasteners you removed.
- Replace the glass as you removed it. It will sometimes be necessary to move it a little so that it fits properly in its guide.
- Reconnect the connectors.
- Replace the seals that you have carefully removed.
- Replace the entire door trim.
It's done, you now have a new and working window regulator . So you have to switch on and test it.