The advantage of an electric window regulator is substantial in comparison with manual systems. However, it has the disadvantage of being much more complicated in terms of repairs. Also, it is not necessarily easy to identify precisely the source of the failure. Here we will see how to replace the electric window regulator of a Seat Ibe . But before seeing the procedure to follow, you must be sure to know where the failure comes from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple small repair will sometimes suffice. Whether it's a false contact, or simply a lack of oiling. Now that you're sure where the problem is, let's get to the heart of the matter.
Replacing a Seat Ibe window regulator: how to do it
Changing a window regulator is quite tedious. Depending on your experience on the subject, count approximately three hours to make sure you have the time you need. Whether on a Seat Ibe or on another vehicle, this manipulation is for experienced DIY enthusiasts. So let's see what to do, step by step. We advise you to take photos at several stages to help you reassemble the new window regulator.
Removing a window regulator on a Seat Ibe
- Remove the entire door trim. From the mirror cover to the handle. This should be done very gently using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being obstructed. This step is quite long to perform.
- Remove the window regulator seals from your Seat Ibe. Again, it is wiser to take it delicately.
- Now that you have accessed the window regulator, disconnect the connectors. You will then have to disengage the window lifter motor if it is stuck.
- Take out all the fasteners that hold the glass, then remove it. It is sometimes preferable to place the window halfway up to be able to carry out this operation. Of course we will have to be very careful when handling the glass. It is best to put it on a rather thick sheet.
- Remove the window regulator completely. It is wiser to remember your position. You can take a picture of it if it helps you fix the new window regulator. The window regulator is sometimes held in place by screws or rivets, it is therefore necessary to remove them.
Installation of an electric window regulator for a Seat Ibe
- Fit the new window regulator. Make sure that its position is similar to the previous window regulator. You will certainly need to use the fasteners you removed.
- Replace the glass just as you removed it. It will sometimes be necessary to move it slightly so that it fits properly in its guide.
- Connect the connectors.
- Replace the seals you removed.
- Replace the entire door trim.
That's it, you now have a new and working window regulator . You will therefore have to switch on and test it.