The advantage of an electric window regulator is undeniable in comparison with manual mechanisms. However, it has the disadvantage of being much more complicated in terms of repairs. Also, it is not always easy to pinpoint the source of the fault. With this article, we will discover how to repair the electric window regulator of a Seat Malaga . But before seeing the procedure to follow, you must be certain to understand where the problem came from. Let's be clear, it is sometimes unnecessary to change the entire window regulator, a simple repair can sometimes be enough. Whether it's a false contact, or just a lack of oiling. Now that you are sure of the nature of the problem, let's get to the heart of the matter.
Replacing a window regulator in Seat Malaga: how to do it
The change of a window regulator is rather long. Depending on your experience in the field, count approximately three hours to make sure you don't get caught up in time. Whether for a Seat Malaga or another car, this manipulation is for experienced DIY enthusiasts. So let's look at what to do, step by step. We advise you to take pictures at several stages to help you reassemble the new window regulator.
Removing a window regulator on a Seat Malaga
- Remove the entire door trim. From the mirror cover to the handle. This should be done very gently using a flat screwdriver. You must ensure that you have access to the window regulator at all points without being obstructed. This manipulation is the longest to carry out.
- Remove the window regulator seals from your Seat Malaga. Again, it is essential to take it delicately.
- Now that you have access to the window regulator, remove the connectors. You must then remove the motor from the window regulator if it is stuck.
- Remove all the fasteners that hold the glass, then release it. It is sometimes advisable to place the window halfway up to perform this operation. Naturally we will have to be very careful when moving the glass. It is best to put it on a rather thick sheet.
- Remove the window regulator completely. It is essential to memorize your position. You can take a picture of it if it helps you fix the new window regulator. The window regulator is sometimes held by screws or rivets, it will therefore be necessary to remove them.
Installation of an electric window regulator in a Seat Malaga
- Introduce the new window regulator. Make sure that its position is similar to the previous window regulator. You should probably use the fasteners that you have set aside.
- Replace the glass in the same way as you took it out. Sometimes it will be necessary to move it slightly so that it fits properly in its guide.
- Connect the connectors.
- Fit the seals you removed.
- Refit the entire door trim.
It's good, you now have a new and functional window regulator . You must therefore turn on your car and test it.