The advantage of an electric window regulator is enormous compared to manual systems. On the other hand, it has the defect of being much more complicated in terms of repairs. Also, it is not necessarily easy to pinpoint the origin of the problem. In this article, we will see how to repair the electric window regulator of a Seat Ronda . But before you start, be sure you know where the fault is coming from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple repair will often suffice. Whether it's an electrical short circuit, or simply a lack of lubrication. Now that you are sure of the nature of the problem, let us return to our subject.
How to replace a Seat Ronda window regulator
Changing a window regulator is rather tedious. Depending on your expertise on the subject, plan approximately three hours to make sure you don't get caught in the weather. Whether for a Seat Ronda or another vehicle, this repair is for experienced DIY enthusiasts. So let's see how to do it, step by step. It is advisable to take photos at different times to help you install the new window regulator.
Removing a window regulator on a Seat Ronda
- Remove the entire door trim. From the mirror cover to the handle. Rather, this should be done with care using a flat screwdriver. You must ensure that you access the window regulator at all points without being obstructed. This step is quite long to perform.
- Remove the window regulator seals from your Seat Ronda. Again, it is wiser to do it carefully.
- Now that you have accessed the window regulator, disconnect the connectors. You must then release the window lifter motor when it is blocked.
- Remove all the fasteners that hold the glass, then release it. It is sometimes better to place the window halfway up to perform this operation. Of course, extreme care must be taken when moving the glass. It is advisable to put it on a sufficiently thick sheet.
- Remove the window regulator as a whole. It is wiser to remember its location. You can take a picture of it if it helps you fix the new window regulator. The window regulator is at times held in place by screws or rivets, so it will be necessary to remove them.
Installation of an electric window regulator on a Seat Ronda
- Fit the new window regulator. Make sure that its location is similar to the damaged window lifter. You will certainly have to use the fixings that you removed.
- Replace the glass just as you removed it. At times it will be necessary to move it slightly so that it fits correctly in its guide.
- Reconnect the connectors.
- Replace the seals you removed.
- Replace the entire door trim.
That's it, you now have a new and working window regulator . So you have to turn on your car and test it.