The advantage of an electric window regulator is undeniable in comparison with manual window regulators. However, it has the disadvantage of being much more restrictive in terms of repairs. In addition, it is not necessarily easy to pinpoint the nature of the fault. With this article we will see how to replace the electric window regulator of a seat terraavis . But before you start, you need to be sure you know where the malfunction is coming from. Let's be clear, it is from time to time unnecessary to change the entire window regulator, a simple small repair will often suffice. Whether it's an electrical short circuit, or just a lack of lubrication. Now that you are sure of the source of the concern, let us return to our subject.
How to replace a seat terraavis window regulator
The replacement of a window regulator is rather long. Depending on your expertise on the subject, plan around two o'clock to make sure you don't get caught up in time. Whether for a seat terraavis or another vehicle, this manipulation is for experienced DIY enthusiasts. So let's see how to do it, step by step. We advise you to take pictures at different times to help you reassemble the new window regulator.
Removing a window regulator on a seat terraavis
- Remove the entire door trim. From the handle to the mirror cover. This should be done rather gently with a flat screwdriver. You must ensure that you access the window regulator at all points without being obstructed. This manipulation is the longest to carry out.
- Remove the window regulator seals from your seat terraavis. Again, it is crucial to do this carefully.
- Now that you have access to the window regulator, disconnect the connectors. You can then remove the motor from the window regulator if it is stuck.
- Take out all the fasteners that hold the glass, then take it out. It is occasionally advisable to position the window halfway up to carry out this manipulation. Of course, extreme care must be taken when handling the glass. It is best to place it on a rather thick sheet.
- Remove the window regulator completely. It is essential to remember its location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is occasionally held by screws or rivets, so they must be removed.
Installation of an electric window regulator for a seat terraavis
- Position the new window regulator. Make sure that its location is similar to the previous window regulator. You should definitely use the fasteners you have set aside.
- Replace the glass as you removed it. It will be necessary from time to time to rotate it slightly so that it fits correctly in its guide.
- Reconnect the connectors.
- Fit the seals that you have carefully removed.
- Replace the entire door trim.
It's done, you now have a new and working window regulator . So you can switch on and test it.