The advantage of an electric window regulator is undeniable compared to manual mechanisms. However, it has the disadvantage of being much more complex in terms of repairs. Also, it is not always easy to identify precisely the cause of the failure. With this article, we will discover how to change the electric window regulator of a Volkswagen 1600 . But before seeing the procedure to follow, you must be sure to understand where the failure came from. Indeed, it is from time to time useless to replace the whole window regulator, a simple small repair can sometimes be enough. Whether it concerns an electrical short circuit, or simply a lack of lubrication. Now that you are sure of the source of the malfunction, let's get to the heart of the matter.
Replacing a Volkswagen 1600 window regulator: how to do it
The replacement of a window regulator is rather long. Depending on your experience on the subject, count approximately two o'clock to make sure you don't get caught up in time. Whether for a Volkswagen 1600 or another car, this manipulation is for experienced DIY enthusiasts. So let's see how to do it, step by step. It is advisable to take photos at different times to help you install the new window regulator.
Removing a window regulator on a Volkswagen 1600
- Remove the entire door trim. From the mirror cover to the handle. This should rather be done with care using a flat screwdriver. It will be necessary to make sure to have access to the window regulator in any point without being obstructed. This manipulation is quite long to perform.
- Remove the window regulator seals from your Volkswagen 1600. Again, it is essential to do it gently.
- Now that you have access to the window regulator, remove the connectors. You can then remove the motor from the window regulator if it is stuck.
- Release all the fasteners that hold the window, then release it. It is from time to time more advisable to position the window halfway up to be able to carry out this manipulation. Of course you have to be very careful when moving the window. It is best to place it on a sufficiently thick sheet.
- Remove the window regulator completely. It is essential to remember your position. You can take a picture of it if it helps you to install the new window regulator. The window regulator is occasionally held in place by screws or rivets, so they must be removed.
The installation of an electric window regulator of a Volkswagen 1600
- Fit the new window regulator. Make sure that its location is similar to the previous window regulator. You should probably use the fixings that you removed.
- Replace the glass in the same way as you removed it. It will be necessary from time to time to make it move slightly so that it fits correctly in its guide.
- Reconnect the connectors.
- Replace the seals that you have carefully removed.
- Replace the door trim assembly.
It's good, you now have a new and working window regulator . So you can turn on your car and test it.