When the clock stops working, it can get annoying. So you have to change the display bulb of the Citroen Osmose. Even if the dashboard remains operational, it lacks several information in order to circulate in good conditions. This action is not complex to perform, but requires a minimum of rigor. We advise you to take photos at certain stages in order to remember the reverse process, especially regarding connectors. To carry out this task, plan approximately a small half-hour . Regarding tools, a pair of screwdrivers will suffice. Now let's see how to change this bulb, point by point.
How to change the bulb on the Citroen Osmose display
Depending on the release year, the procedure may vary a little. It is likely that some covers or screws are not identical. We therefore suggest the procedure to be followed in general.
- Start by remove the covers of the front panel which prevent access to the display. You can use a flat screwdriver to pry in the grooves. It happens that you have to remove several screws. In this situation, keep them preciously aside.
- Once the facade is completely removed, you must disconnect connectors connected to the clock bulb of your Citroen Osmose. You can thus remove all the connectors from the block, provided you remember the location. Help yourself by taking photos if it can be useful to you.
- Normally you can have access to the damaged bulb. Gently remove the bulb of the clock.
- Compare the new bulb with the old one. This should be similar in terms of base and volume. The tension also obviously.
- Place the new bulb by checking that it is at the bottom of its socket.
- Put the connectors in place as they were.
- Put all the covers on the front.
We invite you to leave us a comment if you have encountered particular concerns.