When the clock stops lighting up, it can be annoying. We will therefore have to replace the display bulb of the Hyundai Kona. Although the dashboard is still operational, we lack certain information to circulate in good conditions. This manipulation is not complex to perform, but requires a minimum of rigor. We advise you to take photos at certain stages to remind you of the reverse manipulation, especially for connectors. To perform this task, plan approximately a small half-hour . Regarding tools, a pair of screwdrivers should suffice. Now let's see how to change this bulb, point by point.
How to change the bulb on the Hyundai Kona display
Depending on the release years, the method may vary a little. It is conceivable that some covers or screws differ. We therefore propose the logic to be followed in general.
- Start with remove the covers of the front panel which obstruct access to the display. You can use a flat screwdriver to pry into the grooves. You may need to remove some screws. Therefore, keep them carefully aside.
- Once the facade has been completely removed, you will need disconnect connectors connected to the Hyundai Kona clock bulb. You can therefore dismantle all of the block's connectors, as long as you remember the location. Help yourself by taking photos if necessary.
- You can normally have access to the damaged bulb. Carefully remove the bulb of the clock.
- Compare the new bulb with the old one. This should be similar in terms of base and volume. The voltage also obviously.
- Place the new bulb making sure it is at the bottom of its socket.
- Put the connectors in place.
- Put all the covers on the front.
You can leave us a comment if you have encountered any particular concerns.