When the clock stops working, it can be annoying. So you have to replace the display bulb from the iveco daily. Although the dashboard remains functional, we lack some indications in order to circulate in sufficient comfort. This action is not complex to perform, but requires a minimum of rigor. We advise you to take photos at different stages to remind you of the reverse manipulation, especially regarding connectors. To execute this manipulation, count approximately a small half-hour . In terms of tools, a pair of screwdrivers is enough. Now let's see how to replace this bulb, step by step.
How to change the light bulb on the iveco daily display
Depending on the release dates, the methodology may vary slightly. Some covers or screws may not be the same. This is therefore the procedure to be followed in general.
- Start with remove the covers of the front panel which prevent accessibility to the display. You can use a flat screwdriver to pry in the grooves. It happens that you have to remove several screws. Therefore, keep them preciously aside.
- Once the facade is completely dismantled, you need disconnect connectors which connect to the clock bulb of this iveco daily. You can therefore remove all the connectors from the block, provided you remember the location. Help yourself by taking photos if it can be useful to you.
- Normally you can have access to the defective bulb. Carefully disassemble the bulb of the clock.
- Compare the new bulb with the previous one. This should be similar in terms of base and volume. The voltage also of course.
- Put in the new bulb by checking that it is at the bottom of its location.
- Put the connectors in place as they were.
- Put all the covers on the front.
We invite you to leave a comment if you have encountered particular concerns.