When the clock stops working, it can be a hassle. So you have to change the display bulb from the Iveco Massif. Although the dashboard remains operational, certain information is missing in order to circulate in sufficient comfort. This action is not difficult to achieve, but requires a minimum of thoroughness. We advise you to take pictures at different stages in order to remember the reverse process, especially for the connectors. To carry out this operation, allow approximately a small half-hour . Regarding tools, a pair of screwdrivers is sufficient. Now let's see how to change this bulb, step by step.
How to change the display bulb of the Iveco Massif
Depending on the production dates, the method may vary a little. It remains likely that several covers or screws are not identical. This is therefore the process to be followed in general.
- Start by remove the covers of the front panel which prevent accessibility to the display. You can use a flat screwdriver to pry in the grooves. It happens that you have to take off some screws. In this case, keep them carefully aside.
- Once the facade has been completely removed, you will need disconnect connectors which connect to the clock bulb of this Iveco Massif. You will be able to remove all the connectors from the unit, provided you remember the location. Help yourself with your camera if necessary.
- You can normally have access to the defective bulb. Carefully disassemble the bulb of the clock.
- Compare the new bulb with the previous one. This should be similar in terms of base and volume. The voltage also obviously.
- Place the new bulb by checking that it is at the bottom of its location.
- Put the connectors in place as they were.
- Put all the covers on the front.
You can leave a comment if you have encountered specific malfunctions.