When the clock runs out of light, it can be annoying. So you have to replace the display bulb of the Iveco Minicab. Even if the dashboard remains functional, it lacks several information in order to circulate comfortably. This operation is not hard to perform, but requires a minimum of thoroughness. We advise you to take pictures at certain stages in order to remember the reverse manipulation, especially for the connectors. To perform this operation, count approximately a small half-hour . In terms of tools, a set of screwdrivers will suffice. Now let's see how to change this bulb, point by point.change-bulb-clock-Iveco-Minicab

How to change the display bulb of the Iveco Minicab

Depending on the year of release, the methodology may vary slightly. It remains possible that some covers or screws are not identical. Here is the process to follow in general.

  • Start with remove the covers of the front panel which obstruct access to the display. You can use a flat screwdriver to pry into the grooves. You may need to remove more than one screw. Therefore, keep them carefully aside.
  • Once the facade has been completely dismantled, disconnect connectors connected to the clock bulb of your Iveco Minicab. You can therefore remove all the connectors from the block, provided you remember the location. Help yourself by taking pictures if that can be helpful.
  • You can normally access the defective bulb. Carefully remove the bulb of the clock.
  • Compare the new bulb with the old one. This should be similar in terms of base and volume. The tension also obviously.
  • Place the new bulb by checking that it is at the bottom of its location.
  • Put the connectors in place.
  • Put all the covers on the front.

Do not hesitate to leave us a comment if you have encountered particular concerns.