When the clock runs out of light, it can be annoying. It will therefore be necessary to replace the display bulb of the Jeep Cj7. Although the dashboard is still operational, we are missing some indications to drive comfortably. This action is not difficult to perform, but requires a minimum of thoroughness. We advise you to take photos at certain stages to remind you of the opposite approach, especially regarding connectors. To perform this task, plan approximately a small half-hour . In terms of tools, a pair of screwdrivers will suffice. Now let's see how to replace this bulb, step by step.change-bulb-clock-Jeep-Cj7

How to change the bulb on the Jeep Cj7 display

Depending on the years of circulation, the methodology may vary slightly. It is likely that several covers or screws are not identical. This is therefore the logic to be followed in general.

  • Start with remove the covers of the front panel which obstruct access to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove a few screws. Therefore, keep them preciously aside.
  • Once the facade is completely removed, you must disconnect connectors which connect to the clock bulb of this Jeep Cj7. You will therefore be able to remove all the connectors from the block, provided you remember the location. Help yourself with your camera if it helps you.
  • Normally you can have access to the damaged bulb. Carefully remove the bulb of the clock.
  • Compare the new bulb with the previous one. The latter must be similar in terms of base and volume. The voltage also of course.
  • Put in the new bulb by checking that it is at the bottom of its socket.
  • Put the connectors in place.
  • Put all the covers on the front.

We invite you to leave a comment if you have encountered specific concerns.