When the clock stops lighting up, it can be unpleasant. So you have to replace the display bulb of the Jeep Commander. Even if the dashboard remains operational, we are missing several indications to drive in sufficient comfort. This action is not hard to perform, but requires a minimum of rigor. We also advise you to take photos at different stages to remind you of the reverse manipulation, especially regarding connectors. To do this, count about a small half-hour . In terms of tools, a set of screwdrivers is enough. Now let's take a look at how to replace this bulb step by step.change-bulb-clock-Jeep-Commander

How to change the bulb of the Jeep Commander display

Depending on the year of discharge, the procedure may vary a little. It is likely that several covers or screws are not identical. So that's the general approach.

  • Start with remove the covers of the facade which hinder accessibility to the display. You can use a flat screwdriver to pry into the grooves. You may need to remove more than one screw. Therefore, keep them preciously aside.
  • Once the facade has been completely removed, disconnect connectors that connect to the Jeep Commander's clock bulb. You can therefore remove all the connectors from the block, provided you remember the location. Help yourself by taking photos if it can be useful to you.
  • You can normally access the broken bulb. Gently remove the bulb of the clock.
  • Compare the new bulb with the previous one. This should be similar in terms of base and volume. The voltage also naturally.
  • Put in the new bulb making sure it is at the bottom of its location.
  • Replace the connectors as they were.
  • Replace all of the front covers.

We invite you to leave us a comment if you have encountered specific problems.