When the clock stops lighting up, it can get annoying. It will therefore be necessary to replace the display bulb of this Kia Sephia 2. Although the dashboard remains operational, we lack several indications to drive in good conditions. This manipulation is not hard to perform, but requires a minimum of thoroughness. We advise you to take pictures at certain stages to remind yourself of the reverse process, especially concerning the connectors. To complete this task, allow approximately a small half-hour . Regarding tools, a pair of screwdrivers should suffice. Now let's see how to change this bulb, point by point.
How to change the display bulb of the Kia Sephia 2
Depending on the year of release, the method may vary slightly. It remains likely that some covers or screws are not identical. This is the general approach to be followed.
- Start by remove the covers of the front panel which obstruct access to the display. You can use a flat screwdriver to pry in the grooves. Sometimes you have to remove a few screws. In this case, keep them preciously aside.
- Once the facade has been completely removed, you must disconnect connectors which connect to the clock bulb of your Kia Sephia 2. You can therefore remove all of the connectors from the unit, provided you remember the location. Help yourself with your camera if that can help.
- You can normally have access to the defective bulb. Carefully remove the bulb of the clock.
- Compare the new bulb with the old one. This should be similar in terms of base and volume. The tension also naturally.
- Put in the new bulb making sure it is at the bottom of its location.
- Replace the connectors as they were.
- Replace all of the front covers.
We invite you to leave us a comment if you have encountered specific malfunctions.