When the clock has no more light, it can be annoying. So you have to replace the display bulb of the Opel Rak E. Although the dashboard remains operational, it lacks certain indications in order to circulate in good conditions. This operation is not hard to perform, but requires a minimum of rigor. It is also advisable to take photos at certain stages in order to remember the reverse process, especially for connectors. To carry out this manipulation, count approximately a small half-hour . Regarding tools, a pair of screwdrivers should suffice. Now let's see how to change this bulb, point by point.
How to change the bulb on the display of the Opel Rak E
Depending on the years of production, the method may vary slightly. It is conceivable that several covers or screws differ. We therefore offer you the logic to follow in general.
- Start by remove the covers of the front panel which prevent access to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove more than one screw. In this case, keep them preciously aside.
- Once the facade has been completely removed, disconnect connectors connected to the clock bulb of the Opel Rak E. You can therefore remove all the connectors from the block, provided you remember the location. Help yourself with your camera if needed.
- Normally you can access the damaged bulb. Gently remove the bulb of the clock.
- Compare the new bulb with the previous one. The latter must be similar in terms of base and volume. The voltage also obviously.
- Put in the new bulb making sure it is at the bottom of its socket.
- Put the connectors in place as they were.
- Put all the covers on the front.
You can leave us a comment if you have encountered specific problems.