When the clock stops lighting up, it can get annoying. So we will have to change the display bulb of this Seat 124. Even if the dashboard remains functional, we lack some information in order to drive comfortably. This manipulation is not difficult to perform, but requires a minimum of rigor. It is also advisable to take pictures at certain stages in order to remember the reverse manipulation, especially concerning the connectors. To perform this manipulation, allow about a small half-hour . For tools, a set of screwdrivers is sufficient. Now let's see how to replace this bulb, step by step.
How to change the bulb on the Seat 124 display
Depending on the release dates, the method may vary slightly. It remains likely that some covers or screws differ. Here is the procedure to follow in general.
- Start with remove the covers of the front panel which hinder access to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove some screws. Therefore, keep them carefully aside.
- Once the facade is completely removed, you need disconnect connectors which connect to the clock bulb of this Seat 124. You can therefore remove all of the connectors from the unit, provided you remember the location. Help yourself with your camera if needed.
- Normally you can access the defective bulb. Gently remove the bulb of the clock.
- Compare the new bulb with the old one. The latter must be identical in terms of base and volume. The tension also obviously.
- Put in the new bulb by checking that it is at the bottom of its location.
- Put the connectors in place.
- Put all the covers on the front.
We invite you to leave a comment if you have encountered specific problems.