When the clock stops lighting up, it can get annoying. So you have to change the display bulb Seat 600. Even if the dashboard is still operational, some indications are missing in order to circulate in good conditions. This manipulation is not difficult to execute, but requires a minimum of rigor. It is also advisable to take photos at certain stages to remind you of the reverse manipulation, especially for connectors. To perform this operation, count approximately a small half-hour . In terms of tools, a pair of screwdrivers will suffice. Now let's take a look at how to change this bulb step by step.
How to change the bulb on the Seat 600 display
Depending on the release dates, the methodology may vary slightly. It is likely that several covers or screws are not identical. Here is therefore the logic to be followed in general.
- Start with remove the covers of the front panel which obstruct access to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove more than one screw. In this case, keep them carefully aside.
- Once the facade has been completely removed, it will disconnect connectors connected to the clock bulb of your Seat 600. You will be able to remove all the connectors from the block, so that you remember the location. Help yourself by taking photos if it can be useful to you.
- You can normally have access to the damaged bulb. Carefully disassemble the bulb of the clock.
- Compare the new bulb with the old one. This should be similar in terms of base and volume. The voltage also of course.
- Place the new bulb by checking that it is at the bottom of its socket.
- Replace the connectors as they were.
- Replace all of the front covers.
We invite you to leave us a comment if you have encountered specific problems.