When the clock stops lighting up, it can be unpleasant. So you have to change the display bulb from the seat altea. Even if the dashboard is still operational, some information is missing to drive in good conditions. This manipulation is not hard to execute, but requires a minimum of rigor. We advise you to take photos at certain stages to remind you of the reverse manipulation, especially for connectors. To carry out this manipulation, plan approximately a small half-hour . For tools, a set of screwdrivers will suffice. Now let's look at how to replace this bulb, point by point.change-bulb-clock-seat-altea

How to change the bulb in the seat altea display

Depending on the years of circulation, the method may vary a little. It is conceivable that some covers or screws differ. We therefore offer you the logic to follow in general.

  • Start with remove the covers of the facade which hinder accessibility to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove a few screws. Therefore, keep them preciously aside.
  • Once the facade has been completely removed, disconnect connectors that connect to the seat altea clock bulb. You can therefore remove all the connectors from the block, provided you remember the location. Help yourself by taking photos if necessary.
  • Normally you can have access to the damaged bulb. Gently remove the bulb of the clock.
  • Compare the new bulb with the previous one. The latter must be similar in terms of base and volume. The tension too of course.
  • Put in the new bulb making sure it is at the bottom of its socket.
  • Put the connectors in place.
  • Put all the covers on the front.

You can leave us a comment if you have encountered any particular problems.