When the clock stops working, it can be unpleasant. It will therefore be necessary to replace the display bulb of the Smart Forvision. Although the dashboard is still operational, we lack some information to drive in good conditions. This action is not hard to perform, but requires a minimum of rigor. We also advise you to take photos at different stages to remind you of the reverse manipulation, especially for connectors. To carry out this manipulation, plan approximately a small half-hour . Regarding tools, a pair of screwdrivers is sufficient. Now let's take a look at how to replace this bulb step by step.change-bulb-clock-Smart-Forvision

How to change the bulb on the Smart Forvision display

Depending on the year of discharge, the procedure may vary slightly. Several covers or screws may not be identical. Here is therefore the logic to be followed in general.

  • Start with remove the covers of the front panel which prevent accessibility to the display. You can use a flat screwdriver to pry into the grooves. You may need to remove a few screws. In this situation, keep them carefully aside.
  • Once the facade has been completely removed, you must disconnect connectors that connect to the clock bulb on your Smart Forvision. You can thus dismantle all of the block's connectors, provided you remember the location. Help yourself by taking photos if necessary.
  • Normally you can have access to the damaged bulb. Carefully remove the bulb of the clock.
  • Compare the new bulb with the old one. The latter must be identical in terms of base and volume. The voltage also of course.
  • Place the new bulb making sure it sits well at the bottom of its socket.
  • Put the connectors in place as they were.
  • Put all the covers on the front.

You can leave a comment if you have encountered specific malfunctions.