When the clock runs out of light, it can be annoying. So you have to change the display bulb of the Suzuki Samurai. Although the dashboard remains operational, we are missing several pieces of information in order to drive comfortably. This operation is not hard to execute, but requires a minimum of thoroughness. We advise you to take photos at different stages in order to remind you of the opposite approach, especially regarding connectors. To perform this task, allow about a small half-hour . For tools, a set of screwdrivers is sufficient. Now let's see how to replace this bulb, step by step.
How to change the bulb on the Suzuki Samurai display
Depending on the release year, the procedure may vary slightly. It is conceivable that some covers or screws are not identical. This is therefore the logic to be followed in general.
- Start with remove the covers of the front panel which prevent access to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove a few screws. In this case, keep them carefully aside.
- Once the facade is completely dismantled, you need disconnect connectors connected to the clock bulb of your Suzuki Samurai. You will be able to remove all the connectors from the block, provided you remember the location. Help yourself with your camera if needed.
- You can normally have access to the damaged bulb. Carefully remove the bulb of the clock.
- Compare the new bulb with the previous one. The latter must be identical in terms of base and volume. The voltage also of course.
- Put in the new bulb making sure it is at the bottom of its location.
- Put the connectors in place.
- Put all the covers on the front.
You can leave a comment if you have encountered any particular concerns.