When the clock stops working, it can get annoying. So you have to change the display bulb of the Suzuki Vitara 4. Even if the dashboard is still operational, we are missing certain indications to drive in sufficient comfort. This manipulation is not difficult to achieve, but requires a minimum of thoroughness. We advise you to take photos at certain stages to remind you of the opposite approach, especially regarding connectors. To carry out this operation, count approximately a small half-hour . In terms of tools, a pair of screwdrivers is enough. Now let's take a look at how to replace this bulb, point by point.
How to change the bulb on the Suzuki Vitara 4 display
Depending on the release dates, the method may vary slightly. It is likely that some covers or screws differ. This is therefore the procedure to be followed in general.
- Start with remove the covers of the front panel which prevent access to the display. You can use a flat screwdriver to pry into the grooves. You may need to remove a few screws. In this situation, keep them carefully aside.
- Once the facade has been completely removed, disconnect connectors which connect to the clock bulb of your Suzuki Vitara 4. You can therefore remove all the connectors from the block, provided you remember the location. Help yourself with your camera if it helps you.
- Normally you can have access to the broken bulb. Gently remove the bulb of the clock.
- Compare the new bulb with the old one. The latter must be similar in terms of base and volume. The voltage also obviously.
- Place the new bulb by checking that it is located at the bottom of its socket.
- Replace the connectors in their location.
- Replace all of the front covers.
You can leave a comment if you have encountered specific malfunctions.