When the clock stops lighting up, it can be unpleasant. It will therefore have to change the display bulb of the Toyota 1000. Although the instrument panel remains operational, it lacks several indications in order to drive comfortably. This manipulation is not complex to perform, but requires a minimum of rigor. We advise you to take pictures at certain stages in order to remind you of the reverse manipulation, especially concerning the connectors. To carry out this manipulation, allow approximately a small half-hour . Regarding tools, a pair of screwdrivers should suffice. Now let's take a look at how to change this bulb step by step.
How to change the display bulb of the Toyota 1000
Depending on the release dates, the method may vary a little. It remains likely that some covers or screws differ. Here is the logic to follow in general.
- Start with remove the covers of the front panel which obstruct access to the display. You can use a flat screwdriver to pry in the grooves. It happens that you have to remove several screws. In this situation, keep them carefully aside.
- Once the facade has been completely removed, disconnect connectors which connect to the clock bulb of your Toyota 1000. You can therefore remove all the connectors from the unit, provided you remember the location. Help yourself with your camera if necessary.
- Normally you can access the defective bulb. Gently dismantle the bulb of the clock.
- Compare the new bulb with the previous one. This should be similar in terms of base and volume. The tension also of course.
- Put in the new bulb by checking that it is at the bottom of its location.
- Put the connectors in place.
- Put all the covers on the front.
Do not hesitate to leave a comment if you have encountered particular malfunctions.