When the clock stops working, it can get annoying. So you have to change the display bulb of the Toyota Aygo. Even if the dashboard remains operational, several indications are missing in order to circulate in good conditions. This operation is not complex to perform, but requires a minimum of thoroughness. We advise you to take pictures at certain stages in order to remind you of the reverse process, in particular concerning the connectors. To carry out this operation, count approximately a small half-hour . In terms of tools, a pair of screwdrivers will suffice. Now let's take a look at how to replace this bulb step by step.
How to change the display bulb of the Toyota Aygo
Depending on the years of production, the procedure may vary a little. It remains likely that some covers or screws are not identical. Here is the general procedure to follow.
- Start with remove the covers front panel that prevent access to the display. You can use a flat screwdriver to pry in the grooves. It happens that you have to remove some screws. In this case, keep them carefully aside.
- Once the facade has been completely removed, it will disconnect connectors connected to the clock bulb of your Toyota Aygo. You can then remove all the connectors from the block, provided you remember the location. Help yourself with your camera if needed.
- You can normally access the damaged bulb. Carefully remove the bulb of the clock.
- Compare the new bulb with the previous one. The latter should be similar in terms of base and volume. The tension as well obviously.
- Put in the new bulb by checking that it is at the bottom of its location.
- Put the connectors in place.
- Put all the covers on the front.
You can leave us a comment if you have encountered particular malfunctions.