When the clock runs out of light, it can get annoying. It will therefore have to change the display bulb of this Toyota Camry 3. Even if the dashboard is still functional, it lacks some indications in order to circulate comfortably. This operation is not difficult to perform, but requires a minimum of thoroughness. We advise you to take photos at certain stages in order to remind you of the reverse manipulation, in particular concerning the connectors. To carry out this operation, count approximately a small half-hour . Regarding tools, a pair of screwdrivers is sufficient. Now let's see how to replace this bulb, point by point.
How to change the light bulb on the Toyota Camry 3 display
Depending on the years of circulation, the procedure may vary a little. It remains likely that several covers or screws are not identical. Here is therefore the logic to be followed in general.
- Start with remove the covers of the front panel which prevent access to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove more than one screw. Therefore, keep them carefully aside.
- Once the facade has been completely dismantled, disconnect connectors which connect to the clock bulb of this Toyota Camry 3. You can therefore remove all the connectors from the block, provided you remember the location. Help yourself with your camera if it helps you.
- Normally you can access the damaged bulb. Carefully remove the bulb of the clock.
- Compare the new bulb with the previous one. This should be similar in terms of base and volume. The voltage also obviously.
- Put in the new bulb making sure it sits well at the bottom of its socket.
- Put the connectors in place.
- Put all the covers on the front.
You can leave us a comment if you have encountered particular malfunctions.