When the clock stops lighting up, it can be unpleasant. So you have to replace the display bulb Toyota Corolla 8. Even if the dashboard is still operational, we lack several indications in order to drive comfortably. This operation is not difficult to perform, but requires a minimum of rigor. We advise you to take pictures at different stages in order to remember the reverse manipulation, especially concerning the connectors. To complete this task, plan approximately a small half-hour . In terms of tools, a set of screwdrivers should suffice. Now let's see how to change this bulb, step by step.
How to change the light bulb on the Toyota Corolla 8 display
Depending on the years of release, the methodology may vary a little. It is likely that some covers or screws differ. We therefore suggest the procedure to follow in general.
- Start by remove the covers front panel that prevent access to the display. You can use a flat screwdriver to pry in the grooves. It happens that you have to remove a few screws. In this case, keep them carefully aside.
- Once the facade is completely dismantled, you need disconnect connectors connected to the clock bulb of your Toyota Corolla 8. You can thus remove all the connectors from the unit, provided you remember the location. Help yourself by taking pictures if needed.
- You can normally have access to the defective bulb. Gently remove the bulb of the clock.
- Compare the new bulb with the old one. The latter must be identical in terms of base and volume. The voltage also obviously.
- Put in the new bulb by checking that it is located at the bottom of its socket.
- Replace the connectors as they were.
- Replace all of the front covers.
Do not hesitate to leave a comment if you have encountered specific concerns.