When the clock runs out of light, it can be annoying. So you have to change the display bulb of the Toyota Corona. Although the dashboard is still operational, we lack some information to circulate in sufficient comfort. This action is not difficult to carry out, but requires a minimum of rigor. We advise you to take photos at certain stages to remind you of the reverse process, especially for connectors. To carry out this operation, plan approximately a small half-hour . In terms of tools, a pair of screwdrivers will suffice. Now let's see how to change this bulb, point by point.
How to change the light bulb on the Toyota Corona display
Depending on the release years, the method may vary a little. It is likely that some covers or screws differ. This is the general approach to follow.
- Start by remove the covers of the front panel which prevent access to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove a few screws. In this situation, keep them carefully aside.
- Once the facade has been completely dismantled, disconnect connectors that connect to the clock bulb of your Toyota Corona. This will allow you to remove all of the connectors from the block, provided you remember the location. Help yourself with your camera if it helps you.
- Normally you can have access to the damaged bulb. Carefully remove the bulb of the clock.
- Compare the new bulb with the previous one. The latter must be identical in terms of base and volume. The voltage also of course.
- Put in the new bulb making sure it is at the bottom of its location.
- Replace the connectors as they were.
- Replace all of the front covers.
We invite you to leave us a comment if you have encountered specific concerns.