When the clock doesn't light up, it can be annoying. So you need to replace the display bulb of the Toyota Cressida. Even if the dashboard remains operational, it lacks some information to drive comfortably. This operation is not hard to perform, but requires a minimum of thoroughness. We advise you to take pictures at different stages to remember the reverse process, especially concerning the connectors. To complete this task, plan approximately a small half-hour . In terms of tools, a pair of screwdrivers will suffice. Now let's take a look at how to replace this bulb, step by step.
How to change the display bulb of the Toyota Cressida
Depending on the release dates, the procedure may vary a little. It is conceivable that some covers or screws are not identical. Here is the general procedure to follow.
- Start with remove the covers of the front panel which hinder access to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove some screws. In this case, keep them carefully aside.
- Once the facade has been completely removed, it will disconnect connectors connected to the clock bulb of this Toyota Cressida. You will be able to remove all of the connectors from the block, provided you remember the location. Help yourself with your camera if needed.
- You can normally access the broken bulb. Carefully disassemble the bulb of the clock.
- Compare the new bulb with the old one. The latter must be identical in terms of base and volume. The voltage also of course.
- Place the new bulb by checking that it is located at the bottom of its socket.
- Put the connectors in place as they were.
- Put all the covers on the front.
We invite you to leave a comment if you have encountered particular problems.