When the clock stops lighting up, it can be unpleasant. So you have to change the display bulb of this Toyota Endo. Even if the dashboard remains functional, it lacks certain information to drive in sufficient comfort. This action is not hard to execute, but requires a minimum of rigor. We advise you to take photos at different stages to remember the reverse manipulation, especially for connectors. To execute this operation, count approximately a small half-hour . For tools, a set of screwdrivers is sufficient. Now let's see how to change this bulb, step by step.
How to change the light bulb on the Toyota Endo display
Depending on the year of discharge, the procedure may vary slightly. It remains likely that some covers or screws are not identical. This is the logic to follow in general.
- Start with remove the covers of the front panel which prevent accessibility to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove more than one screw. In this case, keep them carefully aside.
- Once the facade is completely removed, you need disconnect connectors which connect to the clock bulb of this Toyota Endo. You can therefore remove all the connectors from the block, as long as you remember the location. Help yourself with your camera if it helps you.
- Normally you can access the defective bulb. Carefully remove the bulb of the clock.
- Compare the new bulb with the previous one. The latter must be identical in terms of base and volume. The tension also of course.
- Put in the new bulb making sure it is at the bottom of its socket.
- Replace the connectors as they were.
- Replace all of the front covers.
We invite you to leave us a comment if you have encountered specific concerns.