When the clock runs out of light, it can be annoying. So you have to replace the display bulb of this Toyota Fine-s. Even if the dashboard remains operational, we are missing several indications in order to circulate comfortably. This manipulation is not hard to perform, but requires a minimum of rigor. We advise you to take photos at certain stages in order to remember the reverse manipulation, especially regarding connectors. To carry out this manipulation, count approximately a small half-hour . In terms of tools, a set of screwdrivers should suffice. Now let's take a look at how to replace this bulb step by step.
How to change the bulb on the Toyota Fine-s display
Depending on the production dates, the method may vary a little. It is likely that some covers or screws are not identical. Here is the procedure to follow in general.
- Start with remove the covers of the front panel which obstruct access to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove more than one screw. In this case, keep them carefully aside.
- Once the facade is completely dismantled, you must disconnect connectors which connect to the clock bulb of the Toyota Fine-s. This will allow you to dismantle all of the block's connectors, provided you remember the location. Help yourself with your camera if needed.
- You can normally access the defective bulb. Carefully remove the bulb of the clock.
- Compare the new bulb with the previous one. This should be similar in terms of base and volume. The tension as well, of course.
- Put in the new bulb by checking that it is at the bottom of its location.
- Put the connectors in place as they were.
- Put all the covers on the front.
You can leave us a comment if you have encountered any particular concerns.