When the clock stops working, it can be unpleasant. It will therefore be necessary to replace the display bulb Toyota Hi Ace 3. Even if the dashboard remains functional, we lack some information to drive comfortably. This manipulation is not complex to perform, but requires a minimum of rigor. It is indeed advisable to take photos at different stages to remember the reverse manipulation, especially regarding the connectors. To carry out this manipulation, count approximately a small half-hour . In terms of tools, a pair of screwdrivers should suffice. Now let's take a look at how to replace this bulb, step by step.
How to change the bulb on the Toyota Hi Ace 3 display
Depending on the release dates, the procedure may vary a little. It is likely that several covers or screws are not identical. Here is the procedure to follow in general.
- Start with remove the covers of the front panel which prevent access to the display. You can use a flat screwdriver to pry in the grooves. Sometimes you have to remove a few screws. In this case, keep them carefully aside.
- Once the facade has been completely removed, it will disconnect connectors connected to the clock bulb of this Toyota Hi Ace 3. You can therefore remove all of the connectors from the block, provided you remember the location. Help yourself with your camera if needed.
- Normally you can have access to the defective bulb. Carefully disassemble the bulb of the clock.
- Compare the new bulb with the old one. This should be similar in terms of base and volume. The tension as well obviously.
- Put in the new bulb making sure it sits well at the bottom of its socket.
- Replace the connectors in their location.
- Replace all of the front covers.
We invite you to leave us a comment if you have encountered particular problems.