When the clock has no more light, it can become annoying. So we will have to change the display bulb of the Toyota I-unit. Even if the dashboard remains operational, we are missing certain information in order to circulate in sufficient comfort. This manipulation is not complex to perform, but requires a minimum of thoroughness. We advise you to take photos at certain stages in order to remind you of the reverse manipulation, especially concerning connectors. To carry out this operation, plan approximately a small half-hour . In terms of tools, a pair of screwdrivers should suffice. Now let's see how to change this bulb, point by point.
How to change the bulb of the Toyota I-unit display
Depending on the release years, the method may vary a little. It is possible that some covers or screws differ. We therefore suggest the logic to be followed in general.
- Start with remove the covers of the front panel which prevent accessibility to the display. You can use a flat screwdriver to pry in the grooves. It happens that you have to remove several screws. In this situation, keep them preciously aside.
- Once the facade has been completely dismantled, disconnect connectors that connect to the clock bulb of the Toyota I-unit. This will allow you to remove all of the connectors from the block, as long as you remember the location. Help yourself with your camera if needed.
- Normally you can have access to the broken bulb. Carefully disassemble the bulb of the clock.
- Compare the new bulb with the previous one. This must be identical in terms of base and volume. The voltage also obviously.
- Put in the new bulb by checking that it is at the bottom of its location.
- Put the connectors in place as they were.
- Put all the covers on the front.
We invite you to leave a comment if you have encountered specific malfunctions.