When the clock stops working, it can get annoying. So we will have to change the display bulb of the Toyota Land Cruiser Serie 150. Even if the dashboard is still operational, some indications are missing to drive in good conditions. This operation is not complex to perform, but requires a minimum of thoroughness. We advise you to take photos at certain stages to remind you of the reverse approach, especially for connectors. To carry out this operation, plan approximately a small half-hour . Regarding tools, a pair of screwdrivers should suffice. Now let's take a look at how to change this bulb, point by point.
How to change the bulb on the display of the Toyota Land Cruiser Serie 150
Depending on the release years, the methodology may vary slightly. It is likely that some covers or screws are not identical. We therefore suggest the procedure to be followed in general.
- Start with remove the covers of the front panel which prevent access to the display. You can use a flat screwdriver to pry in the grooves. It happens that you have to remove several screws. In this case, keep them preciously aside.
- Once the facade has been completely removed, disconnect connectors which connect to the clock bulb of your Toyota Land Cruiser Serie 150. You can therefore remove all the connectors from the block, provided you remember the location. Help yourself by taking photos if it can be useful to you.
- Normally you can access the damaged bulb. Gently remove the bulb of the clock.
- Compare the new bulb with the previous one. The latter must be similar in terms of base and volume. The voltage also obviously.
- Place the new bulb by checking that it is at the bottom of its location.
- Put the connectors in place.
- Put all the covers on the front.
We invite you to leave a comment if you have encountered specific malfunctions.