When the clock stops working, it can get unpleasant. So you have to replace the display bulb of the Toyota Mr 3. Even if the dashboard remains functional, it lacks certain indications in order to drive in sufficient comfort. This operation is not hard to perform, but requires a minimum of thoroughness. We also advise you to take photos at different stages in order to remember the reverse manipulation, especially for connectors. To carry out this task, plan approximately a small half-hour . For tools, a set of screwdrivers is sufficient. Now let's take a look at how to replace this bulb step by step.
How to change the light bulb on the Toyota Mr 3 display
Depending on the release year, the method may vary a little. It is possible that several covers or screws are not identical. Here is therefore the procedure to follow in general.
- Start with remove the covers of the front panel which prevent access to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove a few screws. Therefore, keep them carefully aside.
- Once the facade has been completely removed, disconnect connectors which connect to the clock bulb of this Toyota Mr 3. You will be able to dismantle all of the block's connectors, provided you remember the location. Help yourself with your camera if it helps you.
- Normally you can have access to the damaged bulb. Gently remove the bulb of the clock.
- Compare the new bulb with the old one. The latter should be similar in terms of base and volume. The voltage also obviously.
- Put in the new bulb by checking that it is at the bottom of its location.
- Replace the connectors as they were.
- Replace all of the front covers.
We invite you to leave us a comment if you have encountered specific concerns.