When the clock runs out of light, it can be annoying. So we will have to change the display bulb of the Toyota M. Although the dashboard remains functional, we lack certain indications to circulate in sufficient comfort. This action is not hard to perform, but requires a minimum of rigor. It is also advisable to take photos at certain stages to remind you of the reverse manipulation, especially for connectors. To carry out this operation, plan approximately a small half-hour . In terms of tools, a set of screwdrivers should suffice. Now let's look at how to change this bulb, point by point.
How to change the bulb of the Toyota Mr display
Depending on the years of production, the method may vary a little. It is possible that several covers or screws differ. This is therefore the logic to be followed in general.
- Start by remove the covers of the front panel which obstruct access to the display. You can use a flat screwdriver to pry in the grooves. It happens that you have to remove several screws. Therefore, keep them preciously aside.
- Once the facade is completely removed, you must disconnect connectors which connect to the clock bulb of the Toyota M. You can therefore dismantle all of the block's connectors, provided you remember the location. Help yourself with your camera if it helps you.
- Normally you can access the damaged bulb. Gently remove the bulb of the clock.
- Compare the new bulb with the old one. The latter should be similar in terms of base and volume. The voltage also of course.
- Place the new bulb by checking that it is at the bottom of its socket.
- Replace the connectors in their location.
- Replace all of the front covers.
We invite you to leave a comment if you have encountered specific problems.