When the clock runs out of light, it can get unpleasant. So you have to change the display bulb of the Toyota Paseo. Even if the dashboard is still operational, we are missing some information to drive comfortably. This manipulation is not hard to execute, but requires a minimum of meticulousness. We advise you to take photos at different stages in order to remember the reverse manipulation, especially concerning the connectors. To perform this operation, count approximately a small half-hour . For tools, a set of screwdrivers should suffice. Now let's take a look at how to replace this bulb, point by point.
How to change the bulb on the Toyota Paseo display
Depending on the release dates, the method may vary slightly. It is conceivable that some covers or screws are not identical. We therefore suggest the procedure to be followed in general.
- Start with remove the covers of the front panel which prevent access to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove more than one screw. In this case, keep them preciously aside.
- Once the facade has been completely removed, disconnect connectors which connect to the clock bulb of this Toyota Paseo. This will allow you to remove all of the block's connectors, provided you remember the location. Help yourself with your camera if needed.
- You can normally have access to the defective bulb. Gently dismantle the bulb of the clock.
- Compare the new bulb with the previous one. This should be similar in terms of base and volume. The voltage also obviously.
- Place the new bulb by checking that it is at the bottom of its location.
- Put the connectors in place as they were.
- Put all the covers on the front.
We invite you to leave a comment if you have encountered particular concerns.