When the clock has no more light, it can be annoying. We will therefore have to replace the display bulb of this Toyota Verso. Even if the dashboard is still functional, some information is missing in order to drive in good conditions. This operation is not hard to perform, but requires a minimum of rigor. We advise you to take photos at different stages in order to remind you of the opposite approach, especially regarding connectors. To do this, count roughly a small half-hour . In terms of tools, a set of screwdrivers is enough. Now let's see how to replace this bulb, point by point.change-bulb-clock Toyota Verso

How to change the bulb on the Toyota Verso display

Depending on the release years, the method may vary a little. It remains possible that some covers or screws are not identical. We therefore suggest the procedure to be followed in general.

  • Start by remove the covers of the front panel which prevent access to the display. You can use a flat screwdriver to pry into the grooves. You may need to remove more than one screw. In this situation, keep them carefully aside.
  • Once the facade has been completely removed, it will disconnect connectors that connect to the clock bulb of your Toyota Verso. You can thus remove all the connectors from the block, provided you remember the location. Help yourself with your camera if needed.
  • You can normally access the defective bulb. Carefully remove the bulb of the clock.
  • Compare the new bulb with the previous one. The latter must be identical in terms of base and volume. The voltage as well obviously.
  • Place the new bulb making sure it is at the bottom of its socket.
  • Put the connectors in place.
  • Put all the covers on the front.

You can leave a comment if you have encountered any particular concerns.