When the clock stops working, it can be unpleasant. So you have to replace the display bulb of this Volkswagen Golf 7 R. Although the dashboard is still operational, certain information is missing to drive in good conditions. This action is not difficult to perform, but requires a minimum of thoroughness. We also advise you to take photos at certain stages to remind you of the reverse manipulation, especially for connectors. To carry out this operation, plan approximately a small half-hour . In terms of tools, a pair of screwdrivers should suffice. Now let's take a look at how to replace this bulb, step by step.
How to change the bulb on the Volkswagen Golf 7 R display
Depending on the year of discharge, the procedure may vary slightly. Some covers or screws may not be the same. Here is the procedure to follow in general.
- Start by remove the covers of the front panel which obstruct access to the display. You can use a flat screwdriver to pry into the grooves. It happens that you have to take off some screws. In this situation, keep them carefully aside.
- Once the facade is completely removed, you need disconnect connectors connected to the clock bulb of your Volkswagen Golf 7 R. You can therefore dismantle all of the block's connectors, provided you remember the location. Help yourself by taking photos if necessary.
- You can normally access the defective bulb. Carefully disassemble the bulb of the clock.
- Compare the new bulb with the previous one. The latter must be identical in terms of base and volume. The voltage also of course.
- Put in the new bulb by checking that it is at the bottom of its location.
- Put the connectors in place as they were.
- Put all the covers on the front.
You can leave a comment if you have encountered specific problems.