When the clock runs out of light, it can be annoying. So you have to change the display bulb of this Volkswagen Golf 7 Sw Alltrack. Even if the dashboard remains operational, we lack certain information to circulate in good conditions. This operation is not hard to perform, but requires a minimum of rigor. We also advise you to take photos at different stages to remind you of the opposite approach, especially for connectors. To perform this task, plan approximately a small half-hour . In terms of tools, a set of screwdrivers is enough. Now let's look at how to change this bulb, step by step.
How to change the bulb on the Volkswagen Golf 7 Sw Alltrack display
Depending on the release dates, the method may vary slightly. It is likely that some covers or screws differ. This is therefore the logic to be followed in general.
- Start by remove the covers of the front panel which obstruct access to the display. You can use a flat screwdriver to pry in the grooves. Sometimes you have to remove a few screws. Therefore, keep them carefully aside.
- Once the facade is completely removed, you will have to disconnect connectors which connect to the clock bulb of this Volkswagen Golf 7 Sw Alltrack. This will allow you to remove all the connectors from the block, as long as you remember the location. Help yourself by taking photos if it can be useful to you.
- You can normally access the damaged bulb. Carefully disassemble the bulb of the clock.
- Compare the new bulb with the old one. The latter must be identical in terms of base and volume. The voltage also obviously.
- Place the new bulb by checking that it is at the bottom of its location.
- Put the connectors in place.
- Put all the covers on the front.
Do not hesitate to leave a comment if you have encountered particular concerns.