Replacing the headlight bulb of a Hyundai I-mode is an extremely simple to make . No need to be a great handyman, this repair requires basic tools and no mechanical knowledge. To make this replacement, count about 10 minutes . However, before starting the repairs, you will have to make sure that the malfunction comes from the bulb. We will first see how to find out where the problem is coming from, then how to replace the burnt out bulb.change-bulb-Hyundai-I-mode

The ceiling bulb of your Hyundai I-mode has stopped working: the different origins.

The bulb is defective . This is of course the most common reason. In all cases, you will have to disassemble the light unit from your Hyundai I-mode. To do this, you will have to follow the steps in the following paragraph. To check it is extremely simple. In case it is a filament bulb, you can visually check that its filament is broken. If, on the other hand, it is an LED bulb, it will be necessary to check that the electricity is circulating correctly using a voltmeter. Try to measure the voltage on the two connector poles. An electrical malfunction . It's less common, but it can still happen on a Hyundai I-mode. It is possible that there is a short juice, or that a connector is dirty. In this situation, examine the tension at both ends. In the event that the electricity does not pass correctly, you must follow the wiring until you see the origin of the failure. It is also possible that the connectors are dirty. Then, it will be necessary to clean them with a specialized product and measure the voltage again.

How to replace the ceiling bulb of your Hyundai I-mode

Now that you have found the source of the fault, you are sure the problem is with the bulb. We will see how to replace the ceiling light bulb step by step on a Hyundai I-mode.

  • Remove the ceiling lamp with a flat screwdriver. Pass it in the groove to leverage.
  • Remove the connector
  • Dismount the ceiling light so as to access the bulb
  • Remove the bulb and compare it with the new one. Of course, the size and the base must match
  • Carefully place the new bulb
  • Reposition the connectors and the dome following the reverse procedure

You can now turn on the ignition and check that the bulb is working as it should. It's good, it's done! The interior light bulb of your Hyundai I-mode must work normally. Good walk.