Replacing the ceiling bulb of a hyundai matrix is an extremely manipulation easy to execute . You don't need to be an excellent mechanic, it requires few tools and no mechanical knowledge. To make this replacement, count ten minutes . But before you start the work, you will have to make sure that the malfunction is from the bulb. We will first of all see how to find out where the problem came from, then how to change the burnt out bulb.change-bulb-hyundai-matrix

The ceiling bulb of your hyundai matrix no longer works: the different origins.

The bulb is defective . This is obviously the most common reason. Whatever happens, you will have to remove the lighting unit from the hyundai matrix. To do this, you will have to follow the steps in the next paragraph. To verify it is extremely easy. When it is a filament bulb, you can visually check that this filament is broken. When on the other hand it is an LED bulb, you will have to check that the electricity circulates properly thanks to a voltmeter. Try to take the tension on both sides of the connector. An electrical malfunction . It's less ordinary, however it can still happen on this hyundai matrix. It happens that there is a bad contact, or that a connector is dirty. In this situation, inspect the tension at both ends. When the electricity does not pass properly, it will be necessary to follow the electric cables until the source of the fault is found. It also happens that the connectors are dirty. In this case, it will be necessary to clean them using a specialized product and measure the tension again.

How to replace the ceiling bulb of your hyundai matrix

Once you have found the source of the fault, you are sure the fault is with the bulb. We will see how to change the bulb of the ceiling light step by step on this hyundai matrix.

  • Remove the ceiling light using a flat screwdriver. Insert it into the groove to pry.
  • Disconnect the connector
  • Disassemble the ceiling light so as to access the bulb
  • Remove the bulb and compare it to the new one. Obviously, the dimensions and the base must be identical
  • Place the new bulb carefully
  • Replace the connectors and the ceiling light in the other direction

You can now turn on the ignition and check that the bulb is working properly. It's good, you're done! The ceiling bulb of your hyundai matrix must work normally. Good road.