Changing the light bulb of a Hyundai Pony is a super operation simple to perform . No need to be a great mechanic, this repair requires basic tools and no mechanical knowledge. To perform this operation, count about 10 minutes . But before launching into repairs, you will need to make sure that the problem comes from the bulb. We will first see how to know where the problem came from, then how to change the faulty bulb.change-bulb-ceiling-light-Hyundai-Pony

The overhead lighting on your Hyundai Pony no longer works: the different reasons.

The bulb is defective . This is of course the most common reason. Whatever happens, you're going to have to remove the light block from the Hyundai Pony. To do this, you will need to follow the steps in the next section. To check it is super simple. In case it is a filament bulb, you can visually check that this filament is broken. In the case where on the other hand it is an LED bulb, it will be necessary to check that the electricity circulates properly thanks to a voltmeter. Try to measure the voltage on both sides of the connector. An electrical concern . It's less ordinary, but it can still happen on this Hyundai Pony. There may be a short circuit, or a connector may be dirty. In this case, check the voltage at both poles. In the event that the electricity does not pass properly, you will have to follow the electric wires until you find the origin of the failure. The connectors may also be dirty. In this case, you will have to clean them with a specialized product and measure the tension again.

How to replace the light bulb on your Hyundai Pony

Once you have found the cause of the failure, you are sure that the problem came from the bulb. We will see how to change the bulb of the ceiling light point by point on this Hyundai Pony.

  • Remove the ceiling lamp using a flat screwdriver. Introduce it into the groove to make a lever.
  • Remove the connector
  • Disassemble the ceiling light so as to have access to the bulb
  • Remove the bulb and compare it to the new one. Of course, the size and the base must match
  • Place the new bulb gently
  • Replace the connectors and the ceiling light in the opposite direction

You can now turn on the ignition and check that the bulb is working properly. It's good it's done ! The ceiling bulb of your Hyundai Pony should work normally. Good walk.