Changing the light bulb of a hyundai route is a super manipulation easy to execute . No need to be an excellent mechanic, this repair requires basic tools and no mechanical knowledge. To make this replacement, plan ten minutes . But before starting the work, you will have to make sure that the problem comes from the bulb. We will first discover how to know where the problem comes from, then how to change the burnt out bulb.change-bulb-ceiling-hyundai-ride

The bulb of the ceiling light of your hyundai journey does not work any more: the various reasons.

The bulb is defective . This is of course the most common reason. Whatever happens, you will need to remove the light block from the hyundai ride. To do this, you will have to follow the steps in the next section. To control it is super easy. In case it is a filament bulb, you can visually check that its filament is broken. In the case where on the other hand it is an LED bulb, it will be necessary to check that the current flows properly using a voltmeter. Try to measure the voltage on both sides of the connector. An electrical concern . It's less common, but it can still happen on this hyundai journey. Sometimes there is a short circuit, or a connector is dirty. In this case, check the voltage at both poles. In case the current does not pass properly, you will have to follow the electric wires until you perceive the cause of the failure. It also happens that the connectors are dirty. In this case, it will be necessary to clean them with a specialized product and measure the tension again.

How to replace the light bulb in your hyundai route

Once you have found the cause of the failure, you are certain that the problem comes from the bulb. We will see how to change the bulb of the ceiling light point by point on this hyundai ride.

  • Remove the ceiling light with a flat screwdriver. Pass it in the groove to make a lever.
  • Disconnect the connector
  • Disassemble the ceiling light to access the bulb
  • Remove the bulb and compare it to the new one. Naturally, the dimensions and the base must correspond
  • Place the new bulb gently
  • Replace the connectors and the dome following the reverse procedure

You can now turn on the ignition and check that the bulb is working properly. And now, voila ! The bulb of the ceiling light for your hyundai ride will work normally. Good walk.