Replace the bulb of the ceiling lamp of an Iveco Eurocargo is a very manipulation simple to perform . No need to be a great mechanic, it requires basic tools and no mechanical knowledge. To do this, count ten minutes . However before starting the work, you will have to make sure that the malfunction comes from the bulb. We will first see how to find out where the malfunction comes from, then how to replace the burnt out bulb.changing-light-bulb-ceiling-Iveco-Eurocargo

The bulb of the ceiling lamp of your Iveco Eurocargo does not work anymore: the different origins.

The bulb is defective . This is obviously the most common reason. Whatever happens, you will need to remove the light unit from the Iveco Eurocargo. To do this, you will have to follow the steps in the next paragraph. To control it is very simple. In case it is a filament bulb, you can visually check that this filament is broken. If, on the other hand, it is an LED bulb, you will have to check that the current flows properly using a voltmeter. Remember to take the voltage on both sides of the connector. An electrical malfunction . It's less common, but it can still happen on an Iveco Eurocargo. It happens that there is a false contact, or that a connector is dirty. In this case, examine the voltage at the two poles. In case the current does not pass properly, you will have to follow the electric cables until you see the cause of the failure. It also happens that the connectors are dirty. So, you will have to clean them with a specialized product and measure the tension.

How to replace the ceiling light bulb on your Iveco Eurocargo

Now that you have found the cause of the failure, you are sure that the malfunction comes from the bulb. We will see how to replace the ceiling light bulb step by step on an Iveco Eurocargo.

  • Remove the ceiling light using a flat screwdriver. Insert it into the groove to pry.
  • Remove the connector
  • Disassemble the ceiling light so as to have access to the bulb
  • Remove the bulb and compare it to the new one. Obviously, the size and the base must match
  • Place the new bulb gently
  • Replace the connectors and the dome following the reverse procedure

You can now turn on the ignition and check that the bulb is working properly. And voila, it's done! The ceiling bulb of your Iveco Eurocargo should work normally. Good road.